INDEX General Setting the options Quick start Phone connection Recorder connection Record a call Routine installation Voice terminal connections Audio to recorder Power Beep tone Switch hook Remote start/stop Help Specifications	M1010E EXTERNAL RECORDER INTERFACE comcode: 405 247 255 pec code: 8807-021

General

This guide describes the hookup and features of the M1010E recorder interface module.
The M1010E Recorder Interface Module connects between a voice terminal and your recorder. It provides the recorder with the analog signal necessary for recording voice communications on 7000 and similar series telephones. In addition to the audio (voice) output, the M1010E inserts a beep tone into the conversation to alert and remind both parties that the call is being recorded. Except for the recorder, no additional equipment is required to record conversations from your voice terminal. The M1010E's features include: remote switching, on-hook muting, switchable gain (hi / low), and a beep tone.

Setting the options

All of the options on the M1010E are selected by the 4 position dip switch accessed through the slot in the side of the case. The factory default settings are: beep tone on and normal output level. The factory settings are shown below.

Quick start!

Check that the factory option settings are still set. Four switches are used to select various options, and are visible through the slot on the side of the case. From LEFT to RIGHT (1 TO 4) the switches should appear as shown. Toggle the switches up or down as required to match this configuration.

• Phone connection
  1. Unplug the handset cord from the voice terminal, and insert it in the modular jack on the M1010E.
  2. Connect the pigtail from the M1010E to the handset jack on the voice terminal.

• Recorder connection
  1. Connect the audio cable (mini-phono type) to the center jack on the rear of the M1010E.
  2. Plug the audio cable into the appropriate input jack of the recorder, such as a MIC or LINE input.

  If you are connecting to a remote recorder such as a data logger, use the mini-phono connector supplied to connect to the M1010E to any 2-wire cable.

• Record a call
  1. Set the recorder to record. Place a call as normal. An audible beep should be heard about every 15 seconds. When the call is complete, turn off the recorder.
  2. Verify that a good recording has been made.