Installation

The MI-30DP is factory installed. The analog audio output (recorder audio) has 2 outputs:

1. Pair 2 of the line jack. This is pins 1 & 2 of the line jack, or the orange/white pair.
2. The mini-phone jack on the rear of the set. Use a patch cord with a mini-phone plug on one end, and the proper connector for your recorder on the other end. An attenuating type patch cord is not recommended.

   You can connect to a recorder direct from this jack, located on the rear of the set. MLX-10DP shown, other sets are similar.

• Headset

  To record from a headset, the user must program the lower right feature button for headset status (*782). Refer to "Code Programming" in Avaya’s users guide for the MLX set, or check with your administrator if you are not familiar with programming feature buttons.

Options

• Beep tone

  The beep tone is set by a toggle switch. The switch is accessed through a hole on the back of the voice terminal. The default position for the beep tone option is "on".

  

  To set the beep tone option, remove the desktop stand from the bottom of the voice terminal. Remove the single screw from the wall bracket and remove the wall bracket from the voice terminal. Locate the access hole as shown in the illustration, and set the beep tone as required.