Connections

• Recorder audio connections

  The audio output from the MI6400 is coupled to 2 jacks on the 64XXD+ sets.

  • Line jack

    The MI6400 connects between the voice terminal and the PBX, allowing the recorder audio to use existing spare conductors in the line cord. The line jack retains all the same connectivity as the original jack, plus it provides the analog audio output for recording. Refer to the table for the pin assignments.

    MI6400 recorder interface line wiring
    The recorder audio connections are highlighted.

    DESIGNATION	LINE JACK PIN #	TYPICAL 103 OR 104 BLOCK #	DEFINITY STATION WIRING CODE		PAIR
    Analog audio output for recorder (T)	1	3	white/orange		2
    Analog audio output for recorder (R)	2	4	orange/white		2
    none	3	5	white/green		3
    Ring (R)	4	2	blue/white		1
    Tip (T)	5	1	white/blue		1
    none	6	6	green/white		3
    -48vdc	7	7	white/brown		4
    GRD	8	8	brown/white		4

  • Mini phone jack

    The record audio is also coupled to a mini phone jack on the back of the set. Use the MA1 cable supplied with the MI6400 to connect from this jack to a desktop recorder.

• Power

  The MI6400 operates from the voice terminal's power.

Operation

Two option switches are located on the right side of the set. The switch on the left controls the record-on-demand feature. The switch on the right controls the beep tone function.

• Beep tone

  The factory default mode for the beep tone option is on.

  • Move the TONE switch to the right to set the tone off.
  • Move the switch to the left to set the tone on.

• Record-on-demand

  • Programming ROD

    You must program the 2nd feature button from the bottom on the right hand side of the set for: MAN-MSG-WT. (Manual message waiting)
    The set will prompt you for an extension number. Enter your extension number. Label this feature button "ROD".

  • Using ROD

    The factory default mode for the record-on-demand feature is disabled.
    When this feature is disabled, the audio is always recorded when the set is in use.
    Move the ROD option switch to the right to enable selective recording. Once you have enabled record-on-demand, use the "ROD" feature button to toggle the record-on-demand feature on or off.

    • Conversations are recorded when the green ROD feature indicator is on.
    • Conversations are not recorded when the ROD feature indicator is off.
    Moving the ROD option switch to the left disables record-on-demand.

• Headset instructions

  For headset use, you must program the bottom feature button on the right hand side of the set for: HEADSET
  Using this feature button for the headset function allows the recording features of the MI6400 to work with the headset. (Not available on the 6408D+.)

• Feature button assignments

  SET	REQUIRED FEATURE	BUTTON NUMBER	LOCATION
  6408D+ ( 6408D01C )	MAN-MSG-WT	7	2nd from bottom, rightmost column.
  6424D+M ( 6424D02A )	MAN-MSG-WT	23	2nd from bottom, rightmost column.
  	HEADSET	24	Bottom button, rightmost column.

Specifications

MI6400
GENERAL	Operating voltage	5vdc (internal)
	Beep tone	1400Hz; 200ms burst; 15 sec. interval
INCLUDED ITEMS	1ea. MA1 cable	3ft length. 1/8" mini phone plug to 1/8" mini phone plug. For use with portable cassette recorders or similar devices with 1/8" jack