Connections

Two jacks are located on the rear of the SDC110. Each jack operates 5 of the lamps. Both are RJ-25 modular jacks. Note that pin 6 is common to both J1 & J2.

• Power

  A wall-plug style, 24vdc power supply is included with the SDC110. Use the 24V+ and 24V- terminals. The GRD terminal is common to the ground pin of the 120vac plug.

SDC110 pin-out

SDC110 PIN-OUT

LAMP	JACK	PIN	DESIGNATION
1	J1	1	-24V
2	J1	2	-24V
3	J1	3	-24V
4	J1	4	-24V
5	J1	5	-24V
6	J2	1	-24V
7	J2	2	-24V
8	J2	3	-24V
9	J2	4	-24V
10	J2	5	-24V
1-10	J1	6	+GND
1-10	J2	6	+GND

Mounting

• Desk

  The SDC110 may be placed flat or at an angle using the desktop stand.

• Wall

  For wall mounting remove the desktop stand. The wall bracket has 2 keyholes that accept #4 screws. Locate the holes 2.21 inches apart vertically.

Desktop stand

• Removing

  The SDC110 is shipped with the desktop stand installed. To remove the stand, hold the SDC110 vertically and press down on the stand. The stand will pivot towards the wall bracket. Push it all the way against the wall bracket, then grab the 2 ears and remove it from the SDC110.

• Installing

  The stand pivots into place. One side of the ears are notched. These notches must go in first. Hold the ears of the stand and insert the notched ends next to J1 and J2. Press in and rotate the stand into position.

Specifications

SDC110
GENERAL	Size	5.8"L x 3.4"W x 2.25"H
	Weight	8oz
	Operating voltage	24vdc
	Power consumption	94mA
INCLUDED ITEMS	1ea. PS24.25	24volt, 0.25amp power supply
	2ea. MA15 cable	6ft. length. 6-conductor RJ25 plug to RJ25 plug, reversed wiring.
PS24.25 SUPPLY
GENERAL	Type	regulated, wall plug
	Size	2.95"L x 2.72"W x 1.93"H
	Operating voltage	102-129vac, 60hz, .15a
	Weight	12oz
	Output voltage	24vdc
	Output current	0.25a maximum