Programming

Numbers and variables are stored using a basic touch tone phone plugged into the program RJ11 jack.

• Storing a number

  To store a number, enter *** followed by a ckt number 1 thru 8, followed by 1 to 16 digits. 5 seconds after the last entry, the number is stored in memory and the active indicator flutters. Numbers can include * and # and autovon digits.

• Delete a number

  To delete a number enter *** followed by the ckt number and wait for the timout.

• Set timing

  To store the output timing enter ***9 followed by 2 digits for seconds and tenth seconds.

• Set timeout delay

  To store the timeout delay enter ***0 followed by 2 digits for seconds and tenth seconds.

• LED indicators

  The front panel active indicator blinks when the TTD-100 is idle and turns on solid when touch tones are being received. It flutters to indicate a number being stored in memory. The circuit indicators turn on when the associated circuit is active.

Limitations

Stored numbers can not contain *** or * as a leading digit.
Stored numbers can not contain like sequences. (ie - 1234 and 12345) or be identical.

Connections

Refer to the diagram below for the pinout of the edge connector.

Specifications

TTD100
GENERAL	Size	Type 10 card
	Fuse type	GMT, 0.25 amp
	Operating voltage	24vdc
	Power consumption	50ma
TONES and TIMING	Touch tones	-6vu to -30vu
	Bridge loading	0.1db loss
	Output timing	0.1 to 9.9 seconds
	Interdigit timeout	0.1 to 9.9 seconds
OUTPUT RATINGS	Outputs	8 circuits
	Digits per number	1 to 16
	Output capacity	200 ma @ 200 vdc
	Output resistance	13 ohms