![]() |
|
RD10RD10S & RD10R ringing detector |
![]() |
||||
|
The RD10 is an internal ringing detector. It is compatible with the following AT&T/Lucent/Avaya sets:
When the RD10 detects ringing, the normally open output closes. The RD10 then follows the ringing, opening and closing the output in cadence with the ringing.
The output from the RD10 is a single pole, normally open (form “A”) contact. The output is directed to a 3.5mm mini-phone jack installed on the set.
The RD10R uses a relay for the output closure. The RD10S has a solid state device for the output, protected by a resettable fuse. The fuse will reset after the fault has been removed and does not need replacement.
The RD10 must be factory installed.
The RD10 is always active when the set is plugged in. During speakerphone use, the RD10 is disabled. No user intervention is required.
One MA8 patch cord is supplied. Connect the end with the 3.5mm mini phone plug to the jack on the set. Connect the end with the RJ11 modular plug to the input of your external device, or a 103 type connecting block.

Jumper settings are shown below for verification and reference. It should never be necessary to change the jumper settings on the RD10. The jumpers determine which type of set the RD10 is installed in. Changing the settings may result in erratic operation or no operation.
| SET | JP1 | JP2 |
| 4400 | A | B |
| 6400 | A | A |
| 8400 | A | A |
| 8500 | B | A |
| RD10R and RD10S |
||
| GENERAL | Size (internal) | 2.15"L x 1.175"W x 0.5"H |
| Voltage | 5vdc, powered by the set | |
| Current, solid state output | 4.5mA maximum | |
| Current, relay output | 32mA maximum | |
| Idle current | 1.25mA typical | |
| Ringing detection time | approx. 50ms | |
| OUTPUT, RD10S (solid state output) |
Type | single pole, normally open |
| Capacity | 60v, 100mA; fuse limited | |
| On resistance | 25 ohms, typical | |
| Fuse, resettable | 60v, 100mA | |
| Reset time | <20sec (after fault is removed) | |
| OUTPUT, RD10R (relay output) |
Type | single pole, normally open |
| Capacity | 0.5A 125vac, 1A 24vdc | |
| INCLUDED ITEMS | 1ea. MA8 cable | 6ft. length. 3.5mm (1/8”) mini phone plug to RJ11 modular plug, pair 1 |